Table of Contents
Advertisement
IP Configuration
How to Add an Entry to the IP Routing Table
•
•
Options
The following options are available:
•
•
•
From the SCE(config)# prompt, type ip route prefix mask next-hop, and press Enter.
Step 1
Adds the specified IP routing entry to the routing table.
How to Add an Entry to the IP Routing Table: Example
The following example shows how to set the router 10.1.1.250 as the next hop to subnet 10.2.0.0.
SCE(config)#ip route 10.2.0.0 255.255.0.0 10.1.1.250
Displaying the IP Routing Table
•
•
How to Display the Entire IP Routing Table
From the SCE# prompt, type show ip route and press Enter.
Step 1
Displays the entire routing table and the destination of last resort (default-gateway)
Displaying the Entire IP Routing Table: Example
This example shows how to display the routing table.
SCE#show ip route
gateway of last resort is
|
|-----------------|------------------|-----------------|
|
|
|
|
How to Display the IP Routing Table for a Specified Subnet
•
•
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
5-54
Options, page 5-54
How to Add an Entry to the IP Routing Table: Example, page 5-54
prefix — IP address of the routing entry, in dotted notation.
mask — The relevant subnet mask, in dotted notation
next-hop — The IP address of the next hop in the route, in dotted notation.
Must be within the MNG interface subnet.
How to Display the Entire IP Routing Table, page 5-54
How to Display the IP Routing Table for a Specified Subnet, page 5-54
prefix
|
mask
10.2.0.0 |
255.255.0.0
10.3.0.0 |
255.255.0.0
198.0.0.0 |
10.1.60.0 |
255.255.255.0 |
Options, page 5-55
Displaying the IP Routing Table for a Specified Subnet: Example, page 5-55
Chapter 5
10.1.1.1
|
next hop
|
10.1.1.250 |
|
10.1.1.253 |
255.0.0.0 |
10.1.1.251 |
10.1.1.5
Configuring the Management Interface and Security
|
|
OL-7827-12
Advertisement
Table of Contents
