Table of Contents
Advertisement
Chapter 6
Configuring the Line Interface
How to Configure a Range of Gigabit Ethernet Line Interfaces
At the SCE# prompt, type configure and press Enter.
Step 1
Enters Global Configuration mode.
At the SCE(config)# prompt, type interface range GigabitEthernet 0/port range and press Enter.
Step 2
Where port range is defined as follows:
•
•
Enters Interface Configuration mode for the selected range of GBE interfaces.
Step 3
At the SCE(config if range)# prompt, type auto-negotiate
Enables autonegotiation for all the interfaces in the specified range.
Step 4
At the SCE(config if range)# prompt, type exit and press Enter.
Exits to global configuration mode, from which you can access a different Gigabit Ethernet interface.
Configuring a Range of Gigabit Ethernet Line Interfaces: Example
This example illustrates how to configure autonegotiation on ports 1 and 2 of an SCE platform.
SCE>configure
SCE(config)interface range GigabitEthernet 0/1-2
SCE(config if range)
SCE(config if range)
SCE(config)
Tunneling Protocols
•
•
•
•
Tunneling technology is used across various telecommunications segments to solve a wide variety of
networking problems. The SCE platform is designed to recognize and process various tunneling
protocols in several ways. The SCE platform is able to either ignore the tunneling protocols ("skip" the
header) or treat the tunneling information as subscriber information ("classify"). A special case of
classification by tunneling information is MPLS/VPN with private IP support
OL-7827-12
SCE 2000: any range of the interface numbers between 1 and 4
SCE 1000: 1-2
auto-negotiate
exit
Managed VPNs, page 6-5
Selecting the Tunneling Mode, page 6-6
Asymmetric L2 Support, page 6-13
Displaying the Tunneling Configuration, page 6-13
and press Enter,
,
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Tunneling Protocols
6-3
Advertisement
Table of Contents
