Table of Contents
Advertisement
Configuring VAS Traffic Forwarding
How to Remove the VLAN Tag Number from a Specified VAS Server
From the SCE(config if)# prompt, type no VAS-traffic-forwarding VAS server-id number VLAN and
Step 1
press Enter.
You can also use the default form of the command to remove the VLAN tag configuration.
default VAS-traffic-forwarding VAS server-id number VLAN
How to Configure the Health Check
•
•
•
•
•
•
About the Health Check
Use these commands to enable and disable the Health Check, and to define the ports it should use.
By default, the VAS server health check is enabled, however the user may disable it.
Note that the health check will be activated only if all the following conditions are true. If the health
check is enabled, the server state will be Down if one or more conditions are not met:
•
•
•
•
•
To configure VAS server health check for VAS over 10G, see also
VAS over 10G, page
If the health check of the server is disabled, its operational status depends on the following (requirements
for Up state are in parentheses):
•
•
•
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
12-22
About the Health Check, page 12-22
Options, page 12-23
How to Enable VAS Server Health Check, page 12-23
How to Disable VAS Server Health Check, page 12-23
How to Define the UDP Ports to be Used for Health Check, page 12-23
How to Remove the UDP Ports Configuration, page 12-23
VAS Traffic Forwarding mode is enabled
Pseudo IPs are configured for the SCE platform GBE ports on the VAS traffic link
VAS server is enabled
Server has a VLAN tag
Health check for the server is enabled
12-43.
admin status (enable)
VLAN tag configuration (VLAN tag defined)
group mapping (assigned to group)
Chapter 12
Value Added Services (VAS) Traffic Forwarding
How to Configure Health Check for
OL-7827-12
Advertisement
Table of Contents
