Table of Contents
Advertisement
Chapter 12
Value Added Services (VAS) Traffic Forwarding
Options
The following options are available:
•
•
•
How to Enable VAS Server Health Check
From the SCE(config if)# prompt, type VAS-traffic-forwarding VAS server-id number health-check
Step 1
and press Enter.
How to Disable VAS Server Health Check
From the SCE(config if)# prompt, type no VAS-traffic-forwarding VAS server-id number
Step 1
health-check and press Enter.
How to Define the UDP Ports to be Used for Health Check
From the SCE(config if)# prompt, type VAS-traffic-forwarding VAS server-id number health-check
Step 1
UDP ports source portnumber destination portnumber and press Enter.
How to Remove the UDP Ports Configuration
From the SCE(config if)# prompt, type no VAS-traffic-forwarding VAS server-id number
Step 1
health-check UDP ports and press Enter.
You can also use the default form of the command to remove the UDP port configuration.
VAS-traffic-forwarding VAS server-id number health-check UDP ports
How to Configure Pseudo IP Addresses for the Health Check Packets
•
•
•
•
OL-7827-12
number — The ID number of the VAS server for which to enable or disable the health check
Enable/disable — Enable or disable VAS server health check
Default — Enable
–
UDP ports — Specify the UDP ports to be used for the health check:
source portnumber — health check source port number
–
destination portnumber — health check destination port number
–
Default — <63140,63141>used for server #0 through <63154,63155>used for server #7.
–
About Pseudo IP Addresses, page 12-24
Options, page 12-24
How to Define the pseudo IP Address, page 12-24
How to Delete the pseudo IP Address, page 12-24
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Configuring VAS Traffic Forwarding
12-23
Advertisement
Table of Contents
