Table of Contents
Advertisement
TOS Marking
How to View all Traffic Counters
From the SCE# prompt, type show interface linecard 0 traffic-counter all and press Enter.
Step 1
Displays the value of the each counter and lists the traffic rules that use it.
Viewing the Traffic Counters: Example
The following example displays information for all existing traffic counters.
SCE# show interface linecard 0 traffic-counter all
Counter 'cnt' value: 0 packets. Rules using it: None.
Counter 'cnt2' value: 0 packets. Rules using it: Rule2.
2 counters listed out of 32 available.
How to Reset a Specified Traffic Counter
Step 1
From the SCE# prompt, type clear interface linecard 0 traffic-counter name counter-name and press
Enter.
Displays the value of the specified counter and lists the traffic rules that use it.
How to Reset all Traffic Counters
From the SCE# prompt, type clear interface linecard 0 traffic-counter all and press Enter.
Step 1
Displays the value of the each counter and lists the traffic rules that use it.
TOS Marking
TOS marking is used in IP networks as a means to signal the priority of a flow between network
elements. The Cisco Service Control solution supports the TOS classification on a per-service,
per-package level via the SCA BB application. The SCE platform TOS marking feature enables marking
the TOS field in the IP header of each packet according to the policy configured via the SCA BB console.
The actual TOS value set in the IP header is determined according to the value defined in a configurable
TOS translation table.
TOS marking configuration is performed via the SCA BB console, The SCE platform CLI allows you to
view the state of TOS marking (enabled or disabled) for each interface and to display the TOS translation
table.
For information on configuring TOS marking, please refer to the Cisco Service Control Application for
Broadband User Guide, Rel 3.1.5.
Note
TOS marking in release 3.1.5 is not backwards compatible with any previous SCOS releases.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
6-26
Chapter 6
Configuring the Line Interface
OL-7827-12
Advertisement
Table of Contents
