Configuring The Ip Address Of The Management Interface; Options; Configuring The Ip Address Of The Management Interface: Example - Cisco SCE2020-4XGBE-SM Configuration Manual

Software configuration guide
Table of Contents

Advertisement

Chapter 5
Configuring the Management Interface and Security

Configuring the IP Address of the Management Interface

The user must define the IP address of the management interface. When both management ports are
connected, providing a redundant management port, this IP address always acts as a virtual IP address
for the currently active management port, regardless of which port is the active port.
Note
Changing the IP address of the management interface via telnet will result in loss of the telnet connection
and inability to reconnect with the interface.
Note
After changing the IP address, you must reload the SCE platform (see
SCE Platform, page
components of the SCE platform.

Options

The following options are available:
Connect the SCE platform directly to a local console.
Step 1
Establishes contact with the SCE platform that is not dependent on the configured IP address.
From the SCE(config if)# prompt, type ip address ip-address subnet-mask and press Enter.
Step 2
Configures a new IP address for the management interface
The command might fail if there is a routing table entry that is not part of the new subnet defined by the
new IP address and subnet mask.

Configuring the IP Address of the Management Interface: Example

The following example shows how to set the IP address of the SCE platform to 10.1.1.1 and the subnet
mask to 255.255.0.0.
SCE(config if)#ip address 10.1.1.1 255.255.0.0
OL-7827-12
Options, page 5-57
Configuring the IP Address of the Management Interface: Example, page 5-57
3-15) so that the change will take effect properly in all internal and external
ip-address — The IP address of the management interface. If both management ports are connected,
so that a backup management link is available, this IP address will be act as a virtual IP address for
the currently active management port, regardless of which physical port is currently active.
subnet mask — subnet mask of the management interface.
Rebooting and Shutting Down the
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
IP Configuration
5-57

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sce 2000Sce 1000

Table of Contents