Table of Contents
Advertisement
Configuring the Management Port Physical Parameters
How to Display Current DNS Settings
From the SCE# prompt, type show hosts and press Enter.
Step 1
Displays current DNS settings.
Displaying Current DNS Settings: Example
The following example shows how to display current DNS information.
SCE#show hosts
Default domain is Cisco.com
Name/address lookup uses domain service
Name servers are 10.1.1.60, 10.1.1.61
Host
----
PC85
sce#
Configuring the Management Port Physical Parameters
This interface has a transmission rate of 10 or 100 Mbps and is used for management operations and for
transmitting RDRs, which are the output of traffic analysis and management operations.
The procedures for configuring this interface are explained in the following sections.
•
•
Configuring the Management Interface Speed and Duplex Parameters
This section presents sample procedures that describe how to configure the speed and the duplex of the
Management Interface.
Both these parameters must be configured separately for each port.
•
•
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
5-70
Address
-------
10.1.1.61
Configuring the Management Interface Speed and Duplex Parameters, page 5-70
Monitoring the Management Interface, page 5-72
How to Configure the Duplex Operation of the Management Interface, page 5-71
How to Configure the Speed of the Management Interface, page 5-71
Chapter 5
Configuring the Management Interface and Security
OL-7827-12
Advertisement
Table of Contents
