Configuring VLAN Translation
How to Display the IPinIP Configuration
From the SCE# prompt, type show interface linecard 0 ip-tunnel IPinIP and press Enter.
Step 1
Displays the current configuration for the specified tunnel option.
How to Display the Logged-in VPNs
Options
The following options are available
•
•
From the SCE> prompt, type show interface linecard 0 VPN {name vpn-name | all-names} and press
Step 1
Enter.
How to Display the Asymmetric L2 Support Mode
Step 1
From the SCE# prompt, type show interface linecard 0 asymmetric-L2-support and press Enter.
Configuring VLAN Translation
•
•
•
•
Some topologies require the SCE platform to be able to translate between different VLAN tags.
Figure 6-2
traffic and performing load balancing between two SCE 2000 platforms.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
6-14
vpn-name —The name of a specific currently logged-in VPN for which to display details.
all-names —Use this keyword to display all the VPN names that are currently logged into the
system.
VLAN Translation Features and Limitations, page 6-15
Setting the VLAN Translation Constant, page 6-16
How to Disable VLAN Translation, page 6-17
How to Monitor VLAN Translation, page 6-17
illustrates an example of such a system, in which one router acts as a dispatcher, forwarding
Chapter 6
Configuring the Line Interface
OL-7827-12