Table of Contents
Advertisement
IP Configuration
Options
The following options are available in the IP advertising commands:
•
•
How to Enable IP Advertising
From the SCE(config)# prompt, type ip advertising and press Enter.
Step 1
Enables IP advertising.
How to Configure the IP Advertising Destination
From the SCE(config)# prompt, type ip advertising destination destination, and press Enter.
Step 1
Configures the destination for the IP advertising pings.
How to Configure the IP Advertising Interval
From the SCE(config)# prompt, type ip advertising interval interval, and press Enter.
Step 1
Configures the frequency of the IP advertising pings.
Configuring IP Advertising: Example
The following example shows how to configure IP advertising, specifying 10.1.1.1 as the destination and
an interval of 240 seconds.
SCE(config)#ip advertising destination 10.1.1.1 interval 240
How to Display the Current IP Advertising Configuration
From the SCE> prompt, type show ip advertising and press Enter.
Step 1
Displays the status of IP advertising (enabled or disabled), the configured destination, and the configured
interval
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
5-56
interval — The time interval between pings in seconds.
default interval = 300 seconds
destination — The IP address of the destination for the ping requests
default destination = 127.0.0.1
Chapter 5
Configuring the Management Interface and Security
OL-7827-12
Advertisement
Table of Contents
Need help?
Do you have a question about the SCE2020-4XGBE-SM and is the answer not in the manual?