Chapter 9
Managing Subscribers
About VPN-based Subscribers
All VPN-based subscribers must be cleared to change the tunneling mode. If there are VPN-based
subscribers that the SM cannot remove for some reason (for example, if there is no communication
between the SM and the SCE platform), use this command.
This command allows you to switch out of MPLS/VPN mode without reload when the SM is down.
Use this command ONLY when the SCE platform is disconnected from the SM.
Note
From the SCE(config if)# prompt, type
Step 1
Clears all VPN-based subscribers.
How to Remove Subscribers by Device
You can remove all subscribers managed by a specified device. The device can be either of the following:
•
•
How to Remove Subscribers from the SM
From the SCE(config if)# prompt, type
Step 1
Clears all subscribers from the SM.
How to Remove Subscribers from a Specified SCMP Peer Device
Options
The following option is available:
•
Step 1
From the SCE(config if)# prompt, type
Enter.
Clears all subscribers from the specified SCMP peer device.
OL-7827-12
The SM
A specified SCMP peer device
peer-device-name — the name of the SCMP peer device from which to clear the subscribers.
no subscriber all with-vpn-mappings
and press Enter.
no subscriber sm all
no subscriber scmp name
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Removing Subscribers and Templates
and press Enter.
peer-device-name
and press
all
9-13