Table of Contents
Advertisement
Configuring the SCMP
How to Disable Pushing Sessions
Use this command to disable pushing sessions to the SCE platform. This means that the SCE platform
will pull all sessions from the SCMP peer.
From the SCE(config)# prompt, type no scmp subscriber send-session-start and press Enter.
Step 1
Configuring the SCMP Peer Device to Force Each Subscriber to Single SCE Platform
When SCMP establishes a connection with an SCMP peer device, it informs the device whether the
SCMP is configured to allow each subscriber to be provisioned to only one SCE platform.
Use this command to configure the SCMP peer device to verify that each subscriber is provisioned to
only one SCE platform. If a subscriber was provisioned to a different SCE platform, the SCMP removes
it from the previous SCE platform and provisions it to the new SCE platform. This configuration is
required in MGSCP topology where, if a fail-over between SCE platforms, subscribers might move from
one SCE platform to another. If transferred subscribers are not cleared from the previous SCE platform,
it can cause capacity issues.
Use the no form of the command to allow SCMP to provision subscribers to more than one SCE
platform.
This configuration takes effect only after the connection is re-established.
Default is disabled (subscribers can be provisioned to more than one SCE platform).
Step 1
From the SCE(config)# prompt, type scmp subscriber force-single-sce and press Enter.
How to Disable Forcing Each Subscriber to Single SCE Platform
Use this command to disable forcing each subscriber to only one SCE platform. This allow subscribers
to be provisioned to more than one SCE platform.
From the SCE(config)# prompt, type no scmp subscriber force-single-sce and press Enter.
Step 1
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
14-10
Chapter 14
Managing the SCMP
OL-7827-12
Advertisement
Table of Contents
