Table of Contents
Advertisement
Chapter 12
Value Added Services (VAS) Traffic Forwarding
How to Set the Active VAS Link
•
•
•
Use this command to set the active VAS link, the link on which to transmit VAS traffic after a system
reload and when working in auto-select mode.
When executed, this command triggers an immediate link switch if the currently active VAS traffic link
used is different from the one specified in the command.
Options
The following option is available:
•
How to Set the Active VAS Link
Step 1
From the SCE(config if)# prompt, type VAS-traffic-forwarding traffic-link auto-select
initial-selection {link-0 | link-1} and press Enter.
How to Revert to the Default Active VAS Link Configuration
From the SCE(config if)# prompt, type no VAS-traffic-forwarding traffic-link auto-select
Step 1
initial-selection and press Enter.
You can also use the default form of the command:
default VAS-traffic-forwarding traffic-link auto-select initial-selection
How to Configure Health Check for VAS over 10G
•
•
When configuring the health check for VAS over 10G, you must perform the following steps:
•
•
How to Configure the Health Check IP Address
•
•
OL-7827-12
Options, page 12-43
How to Set the Active VAS Link, page 12-43
How to Revert to the Default Active VAS Link Configuration, page 12-43
VAS traffic-link {link-0|link-1} — The link number on which to transmit VAS traffic
–
Default — Link 1
How to Configure the Health Check IP Address, page 12-43
How to Remove the IP Address Configuration, page 12-44
Configure the health check source and destination IP addresses
Enable health check compatibility for VAS over 10G
About the Health Check IP Address, page 12-44
Options, page 12-44
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
VAS over 10G
12-43
Advertisement
Table of Contents
