Temporarily Change Your Ip Address For Remote Access - Cisco S195 Getting Started Manual

Temporarily Change Your IP Address for Remote Access

Temporarily Change Your IP Address for Remote Access
To remotely configure the appliance using the network connection, you must temporarily change the
IP address of your computer.
Make a note of your current IP configuration settings as you will need to revert to these settings after
Note
you finish the configuration.
Alternatively, you can use the serial console to configure the appliance, without changing the IP address.
If you use the serial console, see
Temporarily Change Your IP Address on Windows
Note The exact steps depend on the version of your operating system.
Procedure
Connect your laptop to the primary Management Port (labeled M1) using the cross over or Ethernet cable
Step 1
included in the system box. The Cisco Web Security Appliance uses the M1 Management port only. See
"Plan the Installation" section on page
Go to the Start menu and choose Control Panel.
Step 2
Double-click Network and Sharing Center.
Step 3
Cisco Web Security Appliance S195, S395, S695, and S695F Getting Started Guide
6
Connect to the Appliance, page
5.
7.