Default Settings; Machine Default Settings - Kyocera KM-C2630D Operation Manual

Section 7 COPIER MANAGEMENT

Default settings

The state that the copier enters at the end of warm-up or when the [Reset] key is pressed is called the "initial mode". The modes, functions and
other settings that are automatically pre-set for the initial mode are called "default settings". These default settings are separated into two
categories: "Copy defaults" and "Machine defaults" and can be changed as desired to suit your copying needs.

Machine default settings

The following table indicates the machine default settings available in this copier. Change any or all of the settings as desired in order to make
the most effective use of your copier.
Default setting
Auto If the paper in one drawer[cassette] runs out during copying,
drawer[cassette] the automatic drawer[cassette] switching function will
switching ON/OFF switch paper feed from the empty drawer[cassette] to
another drawer[cassette] that contains the same size of
paper in the same orientation for uninterrupted copying. To
enable this function, it is necessary to turn the related
setting "On".
In order to prevent a drawer[cassette] that holds a different
type of paper from being switched to when the automatic
drawer[cassette] switching function is turned ON, it is
necessary to select "Feed same paper type" as well.
Paper size Sets the size of paper that is loaded in drawers[cassettes]
(drawer[cassette] No.1 through No.4.
No.1 - No.4) If you want the size to be detected automatically, select
"Auto Detection" (Automatic size detection). If you want to
manually set the size of paper, select "Standard sizes".
* The setting for drawer [cassette] No.1 is not available on
duplex copiers because the Duplex Unit is installed in its
place.
* This setting is only available when the optional Paper
Feeder is installed on your copier.
When "Auto" is selected
Select "Centimeter" or "Inch".
<If you select "Standard sizes">
You can then select the paper size.
Paper type Sets the paper type for drawers [cassettes] No. 1 through No.
(drawer[cassette] 4.
No.1 - No.4) * The setting for drawer[cassette] No.1 will not be available
on duplex copiers because the Duplex Unit is installed in
its place.
* The setting for drawer[cassette] No.2 through No.4 will
only be available when the optional Paper Feeder is
installed on your copier.
* When an optional Document Finisher is installed, be sure
to configure this setting to match the paper weight. An
incorrect setting can cause paper jams.
7-42
Description
Available Factory
settings setting
On / Off On
All types of paper / All types of paper
Feed same paper
type
Auto Detection / Auto Detection
Standard sizes
Centimeter Centimeter
Inch
A3 – – –
A4
A4R
A5R
B4
B5
B5R
Folio
11" × 17"
8 " × 14"
1/2
11" × 8 "
1/2
8 " × 11"
1/2
5 " × 8 "
1/2 1/2
8 " × 13"
1/2
Plain Plain
Preprinted
Recycled
Letterhead
Color [Colour]
Prepunched
Bond
High quality
Rough
Custom 1 – Custom 8
Reference
page
7-46
7-47
7-48