Kyocera KM-C2630D Operation Manual page 263

Setting originals on the platen
When copying from an original which cannot be set in the
Document Processor (books, magazines, etc.), lift open the
Document Processor and set the original directly on the platen.
1
Operate the Document Processor release lever and open the
Document Processor.
NOTE
Before opening the Document Processor, make sure that
there are no originals remaining on the original table or
on the original eject table. If there are originals left in
either place, they may fall off the copier when the
Document Processor is opened.
2
Set the original to be copied face-down and align the edges
with the original size indicator lines.
Section 8 OPTIONAL EQUIPMENT
3
Hold the Document Processor release lever and close the
Document Processor.
IMPORTANT!
Do NOT put undue pressure on the Document Processor
when you close it or there is a chance that you might
break the platen glass.
CAUTION
DO NOT leave the Document Processor open as
there is a danger of personal injury.
8-3