Kyocera KM-C2630D Operation Manual page 126

Section 6 OTHER CONVENIENT FUNCTIONS
2
Configure the finisher settings. You can select "Staple
mode" ["Staple Mode"] or "Saddle Stitch" ["Center Staple"]
for stapling, or "Punch mode" ["Punch Mode"] for punching.
Follow the instructions on the right side of the touch panel
and verify the direction in which the originals were set.
Inch specifications
Ready to Job build.(Full-color)
Place originals then press Start key.
Finished
Offset
Off
On
Metric specifications
Ready to Job build.(Full Col.)
Set original. Press Start key.
Finished
Group
none
1 set
IMPORTANT!
If the designation for the direction that the originals are
set is not correct, copying may be accomplished
incorrectly.
3
Press the "Close" key.
The touch panel will return to the screen in step 1.
6-76
Back
Staple Punch
Check direction
Check direction of
original top side.
Staple Punch
mode mode
None
Saddle
Rear
Stitch
Back
Staple Punch
Check direction
Check direction of
original.
Staple
Punch Mode
Mode
None
Center
Back Edge
Staple
Making copies at an enlarged or reduced
magnification ratio
This procedure selects the magnification ratio of the finished
copies.
1
With the content of the "Basic" tab displayed, press the
"Reduce/Enlarge" key.
set
The "Reduce/Enlarge" screen will be displayed.
Close
Inch specifications
Job Build - Step 1
Left top
corner
Select
paper
Finished
set
Close
Metric specifications
Job Build - Step 1
Left top
corner
Select
paper
Finished
Ready to Job build.(Full-color)
Place originals then press Start key.
11x8 / 1 sided 1 sided copy
1
2
Original 1 sided/
type 2 sided
1 sided copy-Left
Offset AMS Back Edge
Finished page #: 0
Reduce Orig. set
/Enlarge direction
Basic Quality Edit
Ready to Job build.(Full Col.)
Set original. Press Start key.
1-sided 1-sided Copy
Original 1-sided/
type 2-sided
1-sided Copy-Left
Group AMS Back Edge
Finished page #: 0
Reduce/ Orig. set
Enlarge direction
Basic Quality Edit
set
End
Insert
page
set
End
Insert
blank page