Section 2 Names Of Parts - Kyocera KM-C2630D Operation Manual

Section 2 NAMES OF PARTS

(25)
(23)
(16) Original size indicator plate
Be sure to align the original with this plate when setting an
original on the platen.
(17) Platen
Set originals here for copying. Lay originals face-down and
align them with the upper left corner of the platen (towards
the left-rear portion of the copier).
(18) Multi-bypass tray
Load the paper here when printing on to small-size paper or
special paper.
(19) Multi-bypass extension
Pull out this extension when copying onto 8
size paper or larger.
(20) Insert guides
Align these guides to fit the width of the paper that is to be set
on the multi-bypass tray.
(21) Right cover
Open this cover if a paper misfeed occurs inside the copier.
(22) Drawer[Cassette] No.1 (in standard copiers [for 1-sided
copies only])
This drawer[cassette] has a storage capacity of 500 sheets of
copy paper.
Duplex Unit (in duplex copiers [for 2-sided copies])
This unit allows you to make duplex [2-sided] copies.
(23) Paper length guide release levers
Pinch these levers and adjust the guide plate to fit the length
of the paper that is to be loaded in that drawer[cassette].
(24) Paper width guide release levers
Pinch these levers and adjust the guide plates to fit the width
of the paper that is to be loaded in that drawer[cassette].
(25) Top tray
Finished copies can be ejected and stored on this tray.
2-2
(16)
(17)
(22) (24)
" × 11" [A4R]
1/2
(20)
(18)
(19)
(18)
(21)