Making A Margin Space On The Copies [Margin Mode]; Standard Margin; Separate Front And Back Margin Settings - Kyocera KM-C2630D Operation Manual

Section 6 OTHER CONVENIENT FUNCTIONS

Making a margin space on the copies [Margin mode]

Standard margin

Inch specifications
The image of the original can be shifted to the left or right and up
or down to make a margin (blank) space on the copy. The width of
each margin can be set to any 1/8" increment between 0" and 3/4".
A setting of "0" will leave no margin space.
Metric specifications
The image of the original can be shifted to the left or right and up
or down to make a margin (blank) space on the copy. The width of
each margin can be set to any 1 mm increment between 0 mm and
18 mm. A setting of "0" will leave no margin space.
Original
NOTES
• It is also possible for you to select the default setting for
the location and width of the margins.
(See "Margin width" on page 7-92.)
• If you select to have a left margin created during
2-sided copying and the location for the back side
margin is set to "Auto", a right margin that is the same
width as the margin on the front side will be
automatically created on the back side of the copies.
6-12
Copy
Separate front and back margin
settings
Inch specifications
When you are making 2-sided copies, the margin positions and
widths can be selected separately for the front and back sides. The
width of each margin can be set to any 1/8" increment between 0"
and 3/4". A setting of "0" will leave no margin space.
Metric specifications
When you are making 2-sided copies, the margin positions and
widths can be selected separately for the front and back sides. The
width of each margin can be set to any 1 mm increment between
0 mm and 18 mm. A setting of "0" will leave no margin space.
Original
NOTE
This mode is only available in duplex copiers.
1
Set the originals to be copied.
IMPORTANT!
Set originals so that the top edge is facing either the back
or the left of the copier. Setting them in the wrong
direction may cause the margin to be created in the
incorrect position.
2
Press the "Function" tab.
The content of the "Function" tab will be displayed.
Copy