4-5 Setting I/O
Setting when measurement is not possible
With ZW-8000@, non-measurement setting can be used to intentionally set the measurement value to the
clamp value.
This function cannot be used with ZW-7000@/5000@
Example: When skipping occurs in the measurement values at the end of the target
(1)
Workpiece
Important
The measurement value before the execution of filter processing is set to the clamp value.
176
Setting I/O
Sensor Head
(2)
Direction of
workpiece movement
Amount of
(1)
displacement
Amount of
displacement
Condition when the spot is
half on the target, the
incident level decreases
and the measurement
value is unstable
(2)
Setting the
non-measurement
conditions
Unstable measurement
values can be set to
the clamp value.
ZW-8000/7000/5000
User's Manual