STB6684/A Operation Manual
high limit.
————————————————————————————————————
4.5.8 TIME
This zone is used to the time required by each step.
Operational steps for setting the time in the sequence content page:
1)Move the cursor to TIME, the following items will be displayed:
↑(+)
This softkey is used to increase the time. By each press of this key, the time
increases 10ms (when the unit is ms) or 1s (when the unit is s).
↓(-)
This softkey is used to decrease the time. By each press of this key, the time
decreases 10ms (when the unit is ms) or 1s (when the unit is s) .
Use above softkeys to set the time, or numerical keys and [ENTER] to input the desired
time. By the latter way, when ms is selected and the input time is not a multiple of
10, STB6684/A will set the time to a value that approximate to a multiple of 10; when
0ms or 0s is selected, STB6684/A will set the time to AUTO. If [ENTER] is used to end
inputting, the default unit is s.
4.5.9 FILE
See 5.2 for details about the <FILE MANAGE> function.
Chapter 4 [SETUP]
◇ 51