STB6684/A Operation Manual
Measure delay
Charge time
Some programmable zones in the <MEASURE SETUP> page are the same as that in the
<MEASURE DISP> page as shown below. See previous chapter for details about those
programmable zones.
The other programmable zones in the <MEASURE SETUP> page will be specifically dealt
with in the following paragraphs.
HV1 output
I1 maximum charge current(I1_MAX)
HV2 output
I2 maximum charge current(I2_MAX)
Test speed
Average times
Measure range
Measure input internal impedance
Trigger mode
Test mode
4.1.1 RESULT
STB6684/A has two types of result display: CURR(current), RES
(resistance).
If RES is selected, the measure result will show the resistance value.
If CURR is selected, the measure result will show the current value.
Operational steps for the measure result display setting:
1)Move the cursor to RESLUT, the following items will be displayed in the softkey zone:
RES
CURR
2) Use above softkeys to set the mesure result display.
(MEASURE DELAY)
(CHARGE TIME)
(HV_1)
(HV2)
(SPEED)
(AVG)
(RANGE)
(TRIG)
(MODE)
◇ 26
Chapter 4 [SETUP]
(R in_L)