Hv1 - Saluki STB6684 Operation Manual

STB6684/A Operation Manual
12 zones are displayed in this page: MEASURE DISP, HV1, I1_MAX, HV2, I2_MAX,
SPEED, AVG, RANGE, R in_L, TRIG, FILE, MODE. Their specific descriptions will
be dealt with later.
Follwing test conditions will be displayed in the measurement result/ conditions zone.
These conditions can be set in <MEASURE SETUP> or <LIMIT SETUP>.
R / I
BIN number

HV1

HV2
STEP
TIME
————————————————————————————————————
NOTE: In <MEASURE DISP>, press [TEST] to start or stop the test;
————————————————————————————————————
3.1.1 HV1
This function is used to set the voltage output of HV1.
Voltage setting ranges:
STB6684 :
STB6684A: 10V- 1005V
Operational steps for the HV1 setting:
1) Move the cursor to HV1, the following items will be displayed in the softkey zone.
↑(++)
This is a coarse adjustment key to increase the voltage in accordance with the
sequence of some common-used voltage points.Take STB6684A for example, the
common-used voltage points are as follows: 10V，50V，100V，250V，500V，
1000V，1005V.
↑(+)
This key is is a fine adjustment key used to increase the voltage by 1V.
↓(-)
This key is a fine adjustment key used to decrease the voltage by 1V.
↓(--)
press [HV] to sart or stop the high voltage output.
10V –505V
◇ 12
Chapter 3 [DISP]