Measure Delay - Saluki STB6684 Operation Manual

STB6684/A Operation Manual
2) Use above softkeys to set the DISCHARGE function to ON or OFF.

4.1.4 MEASURE DELAY

STB6684/A can set the MEASURE DELAY function.
MEASURE DELAY is the wait time from the end of charge to the beginning of
the test.
The function is mainly used to decrease the interference caused by switching relays, and to
increase the measure accuracy.
In order to damp the effect of noise, the time a measurement costs equals a period of the power
frequency. By a switch with the frequency of 50/60Hz, user can set the measurement time to
20msec or 16 2/3msec.
Ranges: 0S – 1000S
0mS – 1000mS, by a resolution of 10mS.
0S – 1000S, by a resolution of 1S.
Operational steps for the MEASURE DELAY setting:
1）Move the cursor to MEASURE DELAY, the following softkeys are displayed:
↑（+）
It increases the measure delay time.
By each press of this key, the time increases 10mS (when the unit is mS) or 1S
(when the unit is S).
↓（-）
It decreases the measure delay time.
By each press of this key, the time decreases 10mS (when the unit is mS) or 1S
(when the unit is S).
2）Softkeys or numerical keys can be used to set the measure delay time.
When the numerical keys are used to input the desired measure delay time, the following
softkeys are displayed.
■ msec
■ sec
Above softkeys are applied to select the time unit and to end inputting.
When [ENTER] is used to confirm inputting, the default unit is S.
Chapter 4 [SETUP]
◇ 28