Rang - Saluki STB6684 Operation Manual

STB6684/A Operation Manual
2> Use above softkeys to achieve relative operations.
4.5.4 HV
Voltage setting range: STB6684: 10 ---- 500V
————————————————————————————————————
NOTE: Whether set HV or not depends on the selected sequence command.
————————————————————————————————————
Operational steps for setting HV in the sequence content page:
1）Move the cursor to HV, the following softkeys will be displayed:
↑(++)
This is a coarse adjustement softkey used to increase the voltage in accordance with
the sequence of some common-used voltage points. The common-used voltage
points are as follows: 10V，50V，100V，250V，500V，1000V.
↑(+)
This is a fine adjustment softkey used to increase the voltage by 1V.
↓(-)
This is a fine adjustment softkey used to decrease the voltage by 1V.
↓(--)
This is a coarse adjustement softkey used to decrease the voltage in accordance with the
sequence of some common-used voltage points. The common-used voltage points are as
follows: 10V，50V，100V，250V，500V，1000V.
2）User can use the softkeys to adjust the value of HV or the numerical keys to input the
desired HV value. Currently available voltage units (V) will be displayed in the softkey zone
when the numerical keys are used to input the voltage.Pressing the corresponding softkey, the
voltage unit can be selected and the data will be confirmed. When [ENTER] is pressed to
finish the data input, the default voltage unit is V.

4.5.5 RANG

The ranges in <SEQ. CONTENT> are as follows:
STB6684A: 10-----1000V
◇ 48
Chapter 4 [SETUP]