Table of Contents
Advertisement
STB6684/A Operation Manual
8.3 USB remote control system
USB remote control system can control device by USB interface, which fits the protocol of
USBTMC-USB488 and USB2.0.
8.3.1 System configuration
Use USB cable to connect the USB interface on the rear panel to USB port.
8.3.2 Install drive
When using USB to connect STB6684 with computer at first time，the computer will
note："New hardware is found". Then figure 0-2 will appear，select "Install the software
automatically (Recommended)".
Then press"Next"，select the correct path(niusbtmc.inf)，as Figure 0-3，press "Next",
the installation of STB6684 USBTMC drive is finished.
After the drive is installed， user can see "usb test and measurement device", shown as Figure 0-4:
Figure 0-2
Figure 0-3
◇ 96
Chapter 8 Remote Control
Advertisement
Table of Contents
