Installing Line Cards Into Slots 1-7 And 10-17; Filler Plate Removal, Adjustment And Reinstallation - Paradyne 8820 Installation Manual

2. Installation
Installing Line Cards into Slots 1–7 and 10–17
If you are installing only one line card in the BAC, it is recommended that you use
Slot 1 first, and then proceed to fill the other slots in ascending numerical order
(2–9 and 10–18). When you get to Slots 8 and 18, see
Slots 8 and 18
you must ensure that a filler plate covers the remaining empty slots.

Filler Plate Removal, Adjustment and Reinstallation

The BAC comes with the following filler plates installed:
If you are installing line cards in Slots 1–8 or 11–17, you need to remove a
multislot filler plate. After installing the card, you need to adjust the remaining
portion of the filler plate according to the number of cards being installed, and then
reinstall the filler plate. The following table of procedures in
BAC
2-20
on page 2-24. Whenever you are installing additional line cards,
Two single, 0.8-inch (2.03 cm) wide, EMI-gasketed filler plates (for Slots 9
and 18)
Two single, 1-inch (2.54 cm) wide, EMI-gasketed filler plates (for Slots A
and B)
Two receptacle filler plates (for Slots 8 and 17)
Two multislot filler plates (for Slots 1–7 and 10–16)
on page 2-21 will serve as a reference.
November 2004
Installing Line Cards into
Filler Plates for the
8820-A2-GN20-80