Step 3: Verify The Connection Between The Camera And Pc - IAI SP-20000M-PMCL User Manual

SP-20000-PMCL User Manual (Ver. 3.1)

Step 3: Verify the Connection Between the Camera and PC

Use a short ASCII command to verify whether the camera is properly recognized in your setup.
1. Install terminal emulator software capable of serial communication to the PC connected to the camera via
the frame grabber board.
Set the following serial communication.
Baud Rate
Data Length
Start Bit
Stop Bit
Parity
Xon/Xoff Control
2. Enter the command DVN? <CR><LF> from the terminal emulator software.
If correctly connected, response DVN = JAI Corporation will be displayed.
Item
DeviceVendorName
9600
8bit
1bit
1bit
None
None
Short ASCII Command
DVN
- 23 -
Description
DVN? <CR><LF>
Display the device vendor name: "JAI Ltd., Japan"
Preparation