Step 3: Verify The Connection Between The Camera And Pc - IAI SW-4000T-MCL User Manual

SW-4000T-MCL User Manual (2.0)

Step 3: Verify the Connection Between the Camera and PC

Use a short ASCII command to verify whether the camera is properly recognized in your setup.
1. Install terminal emulator software capable of serial communication to the PC connected to
the camera via the frame grabber board.
Set the following serial communication.
Baud Rate: 9600 (Default)
l
Data Length: 8bit
l
Start Bit: 1bit
l
Stop Bit: 1 bit
l
Parity: None
l
Xon/Xoff Control: None
l
2. Enter the command DVN? <CR><LF> from the terminal emulator software.
If correctly connected, response DVN = JAI Ltd., Japan will be displayed.
Item
DeviceVendorName DVN
Short ASCII Command
- 23 -
Description
DVN? <CR><LF>
Display the device vendor name: "JAI Ltd., Japan"
Preparation