Short Ascii Command List; Protocol (Short Ascii Command) - IAI SP-20000M-PMCL User Manual

SP-20000-PMCL User Manual (Ver. 3.1)

Short ASCII Command List

All configuration of the camera is done via the RS-232C port. The camera can be set up from a PC
running terminal emulator software.
Below is the description of the ASCII based short command protocol.
Communication Setting
Baud Rate
Data Length
Start Bit
Stop Bit
Parity
Xon/Xoff Control

Protocol (Short ASCII Command)

Transmit the Setting Command to Camera
NN is any kind of the command.
NN=[Param.]<CR><LF>
Send to camera: GA=0 <CR><LF>
Camera response: COMPLETE<CR><LF>
When a camera receives a valid command, camera will return 'COMPLETE'. If camera receives an
invalid command, camera will return following:
Send to camera: GAX=0 <CR><LF>
Camera response: 01 Unknown Command!!<CR><LF>
Send to camera: GA=10000 <CR><LF>
Camera response: 02 Bad Parameters!!<CR><LF>
9600
8bit
1bit
1 bit
None
None
- 114 -
Short ASCII Command List