IAI SP-20000M-PMCL User Manual page 38

SP-20000-PMCL User Manual (Ver. 3.1)
Pulse Generator Inverter
Clear Source Signal can have polarity inverted.
Pulse Generator Setting Parameters
Display Name
Clock Pre-scaler
Pulse Generator Clock
(MHz)
Pulse Generator Selector
Pulse Generator Length
Pulse Generator Length
(ms)
Pulse Generator
Frequency (Hz)
Pulse Generator Start
Point
Pulse Generator Start
Point (ms)
Pulse Generator End Point 1 to 1048575
Pulse Generator End Point
(ms)
Pulse Generator pulse-
width (ms)
Pulse Generator Repeat
Count
Pulse Generator Clear
Activation Clear Mode for
the Pulse Generators
Pulse Generator Clear
Sync Mode
Pulse Generator Clear
Source
- Pulse Generator Inverter
(Polarity) Pulse Generator
Clear Inverter
Notes:
1. If Pulse Generator Repeat Count is set to "0", the pulse generator works in free-running mode.
2. The output of the same pulse generator cannot be connected to Clear input.
3. If the Camera Link pixel clock is changed, the pixel clock of the pulse generator remains 39.16 MHz.
1 to 4096
[Pixel Clock:39.16MHz] ÷ [Clock Per-scaler]
Pulse Generator 0 ~ 3
1 to 1048575
([Clock Source] ÷ [Clock Per-scaler])
[ Pulse Generator Length (ms)]
0 to 1048574
([Clock Source] ÷ [Clock Per-scaler])
([Clock Source] ÷ [Clock Per-scaler])
[ Pulse Generator End Point (ms)] - [ Pulse Generator Start Point (ms)]
0 to 255
0: Free Run, 1: Level High, 2: Level Low, 3: Rising Edge, 4: Falling Edge
0: Async Mode, 1: Sync Mode
0: Low, 1: High, 3: Acquisition Trigger Wait, 4: FrameActive, 5: ExposureActive, 6: FVAL, 7: LVAL, 8:
PulseGenerator0*, 9: PulseGenerator1*, 10: PulseGenerator2*, 11: PulseGenerator3*, 12: TTL_In1, 13:
CL_CC1_In, 14: nand0, 15: nand1, 16: OPTTL in2, 17: OPLVDS in
0: Non-Inv, 1:Inv
Value
-1
x [Pulse Generator Length]
-1
-1
x [Pulse Generator Start Point]
-1
x [Pulse Generator End Point]
- 38 -
Main Functions