Gpu Cards In Riser Modules; Installing A Gpu Card In A Riser Module - Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

9.9

GPU cards in riser modules

9.9.1

Installing a GPU card in a riser module

Upgrade and Repair Unit
(URU)
Tools: – Phillips PH2 / (+) No. 2 screw driver
– Phillips PH1 / (+) No. 1 screw driver
Preliminary steps
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove all riser modules, see
▶ If no riser module is installed: Remove the corresponding rear air grid, see
"Removing a rear air grid" on page
▶
"Removing the air duct" on page
▶
"Removing the cross bar" on page
Installing the GPU card in a riser module (example NVDIA Tesla A100)
GPU A40/A6000 have the same installation procedure.
RX2540 M6
Expansion cards and backup units
52.
"Removing a riser module" on page
82.
78.
80.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
87.
53.
56.
52.
70.
291