Fuses For Electronic Systems Of Dl, Fda, Gb Reduction Unit, Fpto And Rll Control - Belarus 1523.5 Operator's Manual

2.20.3 Fuses for electronic systems of DL, FDA, GB reduction unit, FPTO and RLL
control
To access the cutout fuses of electronic control systems (ECS), turn off screw 3
(figure 2.20.12) on cap 2 of side console 1 and open the cap.
Figure 2.20.12 – The location of fuses for ECS of DL, FDA, GB reduction unit, FPTO and
The fuses for ECS of DL, FDA, GB reduction unit, FPTO (if mounted) and RLL are
shown in figure 2.20.13.
Cable colors: K – red, O – orange, P – pink, Ч – black, Ж – yellow, С - grey
Figure 2.20.13 – Fuses for ECS of DL, FDA, GB reduction unit, FPTO and RLL
Five cutout fuses (figure 2.20.13) protect the following electric circuits from overcharge:
1 – FDA drive control (7,5 А);
2 – rear axle DL control (7,5 А);
3 – FPTO control, if mounted (7,5 А);
4 – RLL control (7,5 А);
5 – GB reduction unit control, if mounted (15 А);
6 – duplicate (7,5 А).
1 – side console; 2 – cap; 3 – screw.
RLL.
GB reduction unit
Power supply "+12V" after turning
the starter and instruments switch
key to the position "Instruments
power supply"
63
1523.5-0000010 OM
Connector between fuses
FPTO
DL
FDA
Power supply "+12V"
after engine start
Cable of control systems, DL,
FDA and GB reduction unit
Cable of RLL control
system