Affording Access To The Components For Maintenance Services - Belarus 3522.5 Operator's Manual

6.2 Affording access to the components for maintenance services

Before starting maintenance work open facing mask, remove the both side walls,
the cladding panel, and both protecting covers.
To remove the side walls 8 and 9 (Figure 6.2.1) it is necessary to act as follows:
- release the side walls from locking mechanisms 14 engagement with a ferrule 13;
- remove the side walls 8 and 9, having hefted them before.
To remove panel 7 act as follows:
- unscrew four bolts 6;
- remove the panel 7.
To afford access to the units and parts located under the mask 4, the following ac-
tions shall be performed:
- open a lock 1 by pulling control cable handle 2;
- lift the mask 4 up;
- anchor the mask 4 in the opened position by means of a rod 3 in a supporting
bracket 5;
- ensure that the mask 4 is fixed properly in raised position.
To afford access to the units and parts located under the protecting covers 11 and
12 (if they are mounted) the following actions shall be performed:
- unscrew four bolts 10 on each protecting cover;
- remove the protecting covers 11 and 12.
To anchor the panel 7 on the tractor perform the following actions:
- put the panel 7 on top and fix with four bolts 6;
To anchor the protecting covers 11 and 12 the following actions shall be performed:
- put the protecting covers 11 and 12 back and screw four bolts per each protecting
cover;
To mount the side walls 8 and 9 the following actions shall be performed:
- mount the side walls 8 and 9 into the groove in the panel 7;
- snap locking mechanism 14 in ferrule 13;
To level down the mask 4 the following actions shall be performed:
- heft the mask 4 to release the rod 3 out of the bracket 5;
- fix the rod 3 in a clamp on the mask 4;
- to lower the mask 4 to the down position until the relevant to characteristic click
(lock 1 response).
1 – lock; 2 –control cable handle; 3 – rod; 4 – mask; 5 – bracket; 6 – bolt; 7 – panel; 8,
9 – side wall; 10 – bolt; 11, 12 – protecting cover; 13 – ferrule; 14 – locking mechanism.
Figure 6.2.1 – Opening of the mask and removal of the facing
266
https://tractormanualz.com/
3522.5-0000010 OM