Rear Hitch Linkage - Belarus -1523 Operating Manual

BELARUS-1523/1523В/1523.3/1523В.3
The draft control transducer is made in
the form of two draft-measuring fingers
(5) inserted into the bracket (3); they
serve as the axle for attaching the lower
links (4).
The angular position of the finger in the
bracket is determined by the clamp (1)
which enters the slot of the draft-
measuring finger and fastened to the
bracket (3) by screws (2).
The control of the rear hitch linkage
by means of the BOSCH controller is
exercised from the main control panel
RHL (see paragraph
Panel") located on the right-hand side of
the operator's seat as well as by means
of two external control panels (1) located
on the side surfaces of the rear wheel
fenders.
"RHL Control
154
1 – clamp; 2 – clamp fastening bolt (2 pieces); 3
– bracket; 4 – lower link; 5 – draft-measuring fin-
ger (draft control transducer).
1 – external control panel; "П" – RHL lift pushbut-
ton ("L"); "О" – RHL drop pushbutton ("D").
Construction and Operation