Drawbar Hitch Dh-1 -01 - Belarus 1822.3 Operator's Manual

5.4.5 Drawbar hitch DH-1 -01

Figure 5.4.4 – Installation variants scheme of DH-1 -01
Table 5.6 – Basic parameters
Standard size (configuration)
1 Variant
2 Mounting location
3 Purpose
4 Design features
5 Distance between PTO shaft end extension and
connection pin axis, mm
6 Vertical load on DH in hitch point, kN, not more
than
7 Trailing appliance steering angle in horizontal
plane, degrees, not less than
8 Connecting pin diameter, mm
9 Protective mean type
10 Connection point of a protective mean to the
tractor
___________________________________________________________________________________________________________
1)
Implement accessory.
ATTENTION: MOUNTING OF COVER PLATE TO DRAWBAR BOTTOM (WITH
OVERTURN) TO REDUCE HEIGHT OF YOKE POSITIONING AGAINST SUPPORTING
SURFACE IS NOT ALLOWED!
coupling dimensions of DH -1 -01
201
https://tractormanualz.com/
2022.3-0000010 OM
DH -1 -01 (draw bar)
First position
At the bottom of the rear axis body and
rear lifting device
For connection and
trailed, semitrailed implements with
traveling wheels excluding tractor
trailers and semitrailers
Drawbar with possibility to change its
horizontal position against PTO shaft
end butt
400
15
±60
30
Safety chain (rope)
Lifting device bore
Second position
coupling of
500
12
1)