Drawbar Hitch Dh-1М-01 (Draw Bar) - Belarus 1523.5 Operator's Manual

4.4.5 Drawbar hitch DH-1М-01 (draw bar)
Figure 4.4.4 – Installation variant diagram of DH-1М-01 (draw bar)
Table 4.6 – Basic parameters and coupling dimensions of DH -1М-01(draw bar)
Standard size (configuration)
1 Variant
2 Mounting location
3 Assignment
4 Design features
5 Distance between the PTO butt end and the
connecting pin axis, mm
6 Vertical load on DH in hitch point, kN, not more
than
7 Turning angle of the implement trailing device in
horizontal plane, degrees, not less than
8 Connecting pin diameter, mm
9 Protective device type
10 Connection point of the protective device on
the tractor
___________________________________________________________________________________________________________
1)
Implement accessory.
ATTENTION: MOUNTING OF COVER PLATE ON THE DRAW BAR BOTTOM (WITH
OVERTURN) TO REDUCE HEIGHT OF YOKE POSITIONING IN RELATION TO THE
SUPPORTING SURFACE IS NOT ALLOWED!
DH -1М-01 (draw bar)
First position
At the bottom of the rear axis body
and rear lifting device
For connection and coupling of
trailed, semi-trailed implements with
traveling wheels, excluding tractor
trailers and semi-trailers
Draw bar with possibility to change its
horizontal position in relation to the
RPTO butt end
400
15
Safety chain (rope)
Lifting device openings
113
1523.5-0000010 OM
Second position
500
12
±60
30
1)