Kia EV9 2023 Owner's Manual page 575

What to do in an emergency
Checking tire inflation pressure
Operation
1. After driving approximately 7~10 km (4~6 miles, or approximately 10 minutes), stop the
vehicle in a safe, level place.
2. Connect the filling hose directly to the tire valve.
3.Connect the power outlet connector.
4.Adjust the tire inflation pressure to the specified value.
僅 Turn the compressor on to increase the inflation pressure. Turn the compressor off
briefly to check the current inflation pressure. Turn the compressor valve to reduce
the inflation pressure.
WARNING
僅 Do not let the compressor run for more than 10 minutes, otherwise the device will over-
heat and may be damaged.
僅 The tire inflation pressure must be inflated to the proper pressure (Refer to "Tires and
wheels" on page 10-6). If it is not, do not continue driving. Call for road side service or
towing.
CAUTION
僅 If the inflation pressure is not maintained, drive the vehicle a second time, refer to "Dis-
tributing the sealant" on page 8-20. Then repeat the steps.
僅 Use of the TMK may be ineffectual for tire damage larger than approximately 4 mm
(0.16 inches).
僅 We recommend that you contact a professional workshop if the tire cannot be made
roadworthy with the Tire Mobility Kit.
NOTE
When reinstalling the repaired or replaced tire and wheel on the vehicle, tighten the wheel
lug nut to 11~13 kgf・m (79~94 lbf・ft).
Safe use of Tire Mobility Kit
僅 Stop the vehicle in a safe, level place away from traffic.
僅 Set the parking brake.
OMV063008
Tire Mobility Kit
8 21