Kia EV9 2023 Owner's Manual page 19

Electric vehicle guide
僅 Do not put metal objects to the V2L connector or charging hole. It might be a cause of
electric shock.
僅 Do not touch the V2L connector, charging hole or power plug with a wet hand. It might
be a cause of electric shock. Please handle with a dry hand all the time.
僅 Confirm whether there is foreign substance such as water or dust on the V2L connector,
charging hole or power plug before connecting. If you connect it with foreign sub-
stances, it may be a cause of fire or electric shock.
僅 Do not remodel or disassemble the V2L connector. There is a risk of fire, electric shock
or injury.
僅 When the power plug is connected or disconnected to the V2L connector or open or
close the connector cover of the V2L, be careful not to be scratched on the hand.
僅 Do not charge in the following conditions. The accident might occur.
- The V2L connector, charging hole, power plug or cable is damaged, corroded or
rusted.
- The connection part is loose.
僅 Do not use if the sheath of home appliance cables is damaged or broken. There is a risk
of fire, electric shock or injury.
僅 Never use an electric heating appliance like iron, coffee pot, and toaster in the vehicle. It
may cause a fire and injury.
CAUTION
僅 Be well-informed of the manual to prevent accidents.
僅 The V2L discharging mode is blocked automatically in case of overheating. (When the
discharging mode is blocked, check whether the V2L connector or power plug is con-
taminated, worn, corroded or broken or the home appliance capacity is over 16 A. If the
temperature falls to proper level after it is left unattended, you can use it again. Use
proper home appliances.)
僅 Do not remodel or disassemble the provided V2L connector. The failure caused by
remodeling or disassembling is not covered by the warrant.
僅 Do not drop the V2L connector or give a strong impact to it.
僅 Do not place objects on the V2L connector.
僅 Be sure to disconnect the V2L connector from the vehicle when you are finished using
V2L.
僅 When the high voltage battery charge reaches the set discharging limit(%), the operation
stops, and a warning message is displayed on the instrument cluster. If you want V2L
operation, set the discharging limit(%) lower than the current battery charge.
僅 When using various electric products, use them below the maximum power capacity
that can be supplied by the vehicle.
僅 If you use an electrical appliance that exceeds the maximum power capacity that the
vehicle can supply, the operation will stop and a warning message will be displayed on
the instrument cluster. Make sure the total power consumption of the electrical appli-
ance you use does not exceed the V2L maximum power capacity.
僅 Some of the electric products may not operate normally even if the product has power
consumption less than the maximum power capacity provided by the vehicle.
- Electrical products that require high power during initial operation.
- Measuring devices that need to process accurate data.
EV menu
1 13