Disable Equalize - HindlePower Atevo Series Operating/Service Instructions Manual
Microprocessor-controlled float battery charger three phase input 16-1000 adc output
Hide thumbs
Also See for Atevo Series:
- Operating/service instructions manual (164 pages) ,
- Operations (173 pages) ,
- Operating/service instructions manual (316 pages)
Table of Contents
Advertisement
HindlePower Inc
16.2.
16.2. Disable Equalize
Disable Equalize
Disables the EQUALIZE output voltage mode which attempts to equalize the voltage among
battery cells. This action can be triggered by either a binary or analog input. An example use-
case for this feature would be when an aux input connected to a hydrogen sensor fires a 1%
Hydrogen Alarm, this input can disable the EQUALIZE charging.
This is presented as a new selection under the AUX INPUTS menu as an "Action" for either a
binary input
or an
analog
For more information about how to upgrade firmware, see either
depending on the ATevo product you purchased:
•
Originally supplied with firmware v2.6.6 or earlier
•
Originally supplied with firmware v2.7.0 or later
Copyright HindlePower Inc. 2021
input, as seen in the figure below.
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Section 6.5.4
or 6.5.5,
Page 299 of 311
Advertisement
Table of Contents
