HindlePower Atevo Series Operating/Service Instructions Manual page 278

HindlePower Inc
14.3.9. 14.3.9. Replacing Eliminator Filter Replacing Eliminator Filter
Capacitor (C2) – optional Capacitor (C2) – optional
Preparation: Preparation:
• Shut down and lock out all power to ATevo.
• Wait several minutes to allow internal voltage potentials in capacitors to bleed off.
• Remove safety shield and check with a voltmeter.
For ATevo models rated 16-50 Adc: For ATevo models rated 16-50 Adc:
The eliminator filter (C2) consists of a single electrolytic capacitor, with two (2) wires
connected directly to the Power Board (A2).
• See also Service Instruction (JD5078-02).
• Locate the 'blue can' capacitor (C2) at back-left of ATevo:
◦ Style-5070: mounted to top base with a clamping bracket
Removal of Existing Capacitor (C2x) Assembly: Removal of Existing Capacitor (C2x) Assembly:
• Loosen screw on clamping bracket – at base of capacitor.
• Disconnect wires (attached to C2 eliminator capacitor) from Power Board (A2).
Replacement C2 capacitor assembly will have new wires with pre-crimped terminals.
• Remove existing wired eliminator capacitor.
*
The pos(+) and neg(-) wires have different terminals to
eliminate the possibility of connecting in reverse polarity.
Installation of Installation of NEW NEW C2 Capacitor Assembly:
• Connect wires of new C2 capacitor assembly to Power Board.
• Secure new (replacement) C2 capacitor to ATevo base in same location and manner as
one removed above.
• Replace safety shield, and close front panel door.
• Restart ATevo.
For ATevo models rated 75-100 Adc: For ATevo models rated 75-100 Adc:
The C2 filter is mounted next to the C1 filter capacitor(s), and connects to the C1 capacitor
with a bus bar.
• See also Service Instruction (JD5078-03).
Copyright HindlePower Inc. 2021
C2 Capacitor Assembly:
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Page 278 of 311