HindlePower Atevo Series Operating/Service Instructions Manual page 24

HindlePower Inc
2.1. 2.1. Mechanical Diagram and Mechanical Diagram and
Component Location Component Location
ATevo features a mechanical layout and connection diagram screen-printed onto its internal
acrylic safety shield.
ATevo consists of the following components and subsections:
• Rectifier Assembly (A6) – See below
◦ Heatsink, SCR module, Free-Wheeling Diode (CR4),
Polarity Diode (CR1) & DC Shunt (R1)
• A1 – Main Control Board
• A2 – Power Board
• A4 – Auxiliary I/O Board
• A7 – Filter Capacitor (C1x/R9x) Board
or
• C1x – Discrete Filter Capacitor Bank with Bleeder Resistor
• A9 – AC MOV (surge suppressor) Board
• A10 – Remote Temperature Probe – optional, see below
• A12 – Serial Communications Adapter
• A13 – Forced Load Sharing Communications Adapter
• A22 – Ethernet Communications Adapter
• C2 – Eliminator Filter Capacitor
• CB1 – AC Input Circuit Breaker
• CB2 – DC Output Circuit Breaker
• L1 – Main Filter Inductor
• L2 – Secondary Filter Inductor
• T1 – Power Isolation Transformer
For component location and orientation, refer to the internal Component Layout Drawings
found within the Drawings Binders found in Appendix
enclosure type and rectifier assembly. Identify enclosure (Style-5070, -5030, -163, or -198) of a
given ATevo model, per table in
Rectifier Assembly (A6) Rectifier Assembly (A6)
This is a grouping of aluminum heatsink(s), Silicon-Controlled Rectifiers (SCRs), protection
diodes, and a dc shunt. It is mounted in the upper-left side of ATevo in Style-5070/5030, but the
center back panel in Style-163/198. The Rectifier (A6) converts three-phase alternating current
(ac) power to direct current (dc) for the battery.
Remote Temperature Probe (A10) – optional Remote Temperature Probe (A10) – optional
The battery temperature compensation, or 'TempCo', probe (A10) contains a temperature-
Copyright HindlePower Inc. 2021
with 9V Power Supply (P/S-A2)
– optional
– optional
(and input terminals)
(and output terminals)
Section 1.6
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
– optional
– optional
– optional
B. ATevo internal layouts vary, based on
atevo}.
Page 24 of 311