HindlePower Atevo Series Operating/Service Instructions Manual page 152

HindlePower Inc
• If the SD Memory Card contains the bruno.bin file, you will be prompted to upgrade the
Display Application program.
• Select 'Yes' if desired, and a message will confirm the update.
• The charger will reset and prompt you to upgrade the Main Application program again.
• Move the RE-FLASH JUMPER shorting block back to the 'NORM', normal operating position
and press RESET.
• The ATevo will re-boot.
• When it restarts, it will be running the new installed program(s).
Frequently Asked Questions ( Frequently Asked Questions (FAQ
Since the introduction of firmware v2.7.0 with ATevo units that began being sold in 2021,
changes to the process and the format of files used for upgrading firmware have been made –
as detailed in the next
earlier, these changes will mostly not affect you. However, some customers have asked the
following questions.
Q: Q: Can I upgrade my ATevo that was purchased with v2.6.6 or earlier to firmware v2.7.0+?
A A : : Yes. Contact the manufacturer.
Q: Q: Can an ATevo running firmware prior to v2.7.0 use the single file with the new file format?
A A : : No. If your ATevo runs firmware prior to v2.7.0, contact the manufacturer and request the
two old-format firmware upgrade files, then follow the directions above.
Q: Q: What if new and old format firmware files are on a memory card used to update an ATevo?
Copyright HindlePower Inc. 2021
FAQs) s)
topic. If your ATevo was originally supplied with firmware v2.6.6 or
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Page 152 of 311