HindlePower Atevo Series Operating/Service Instructions Manual page 46
Microprocessor-controlled float battery charger three phase input 16-1000 adc output
Hide thumbs
Also See for Atevo Series:
- Operating/service instructions manual (164 pages) ,
- Operations (173 pages) ,
- Operating/service instructions manual (316 pages)
Table of Contents
Advertisement
HindlePower Inc
3. Remove safety shield per
4. Run dc wiring into ATevo, ending at right side of I/O panel.
5. Connect wires to appropriate dc output CU-AL compression lugs on right side of I/O panel.
!
To prevent equipment damage, confirm polarity of pos(+) and neg(-) wiring.
6. Using a flat-blade screwdriver, securely tighten lugs for pos(+) and neg(-) connections.
7. Check all dc output connections, and reinstall safety shield.
2.5.1 I/O Connections (Style-5070)
2.5.1 I/O Connections (Style-5070)
2.5.2 I/O Connections (Style-5030)
2.5.2 I/O Connections (Style-5030)
Copyright HindlePower Inc. 2021
Section
2.2.
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Page 46 of 311
Advertisement
Table of Contents
