HindlePower Atevo Series Operating/Service Instructions Manual page 76

HindlePower Inc
4.1.2. 4.1.2. Factory Settings Tables Factory Settings Tables
Factory settings for each ATevo are summarized below.
*
These values may be revised following a firmware update. For a printable
worksheet, or to access the latest
(JA5124-02).
24 Volt ATevo Set Points & Defaults 24 Volt ATevo Set Points & Defaults
P P arameter arameter
Float Voltage Float V oltage
Equalize Voltage Equalize V oltage
Curr r ent Limit Cur ent Limit
Equalize T Equalize Time ime
High High VDC VDC Alar Alarm m
L L ow ow VDC VDC Alar Alarm m
HVDC HVDC Shutdown Shutdown
High Level Detect High L evel Detect
L L ow L ow Level Detect evel Detect
End of Dischar End of Discharge ge
A A C Ripple Alar C Ripple Alarm m
Gr Ground F ound Fault ault POS POS[+] [+] 1
Gr Ground F ound Fault ault NEG NEG[-] [-]
* 32.00 Vdc High Range Set Point considered "extended equalize". Unit may not meet +/-0.25%
regulation, beyond 31.00 Vdc.
48 Volt ATevo Set Points & Defaults 48 Volt ATevo Set Points & Defaults
P P arameter arameter
Float Voltage Float V oltage
Equalize V Equalize Voltage oltage
Cur Curr r ent Limit ent Limit
Copyright HindlePower Inc. 2021
latest revision of these settings, see online resource
L L ow R ow Range Set P ange Set Point oint High R
22.00
23.40
50% rating
0 (disabled)
24.00
14.00
24.00
24.00
15.00
15.00
50
1
L L ow R ow Range Set P ange Set Point oint High R
44.00
46.80
50% rating
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
High Range Set P ange Set Point oint Nominal (default)
29.50
32.00 *
110% rating
255
38.00
29.50
38.00
35.00
24.00
24.00
500
50
50
High Range Set P ange Set Point oint Nominal (default)
58.00
61.00 *
110% rating
Nominal (default) Units Units
26.00 Volts
28.00 Volts
110% rating Amperes
24 hours
28.80 Volts
24.00 Volts
28.80 Volts
29.40 Volts
20.40 Volts
21.00 Volts
500 milli-Volts
10 kOhms
10 kOhms
Nominal (default) Units Units
52.00 Volts
56.00 Volts
110% rating Amperes
Page 76 of 311