HindlePower Inc
Installation of New C1 Capacitor Assembly:
Installation of New C1 Capacitor Assembly:
• Place new capacitor(s) into brackets maintaining the same polarity as the one(s)
removed.
• Tighten the screw(s) on the capacitor bracket(s).
• Reconnect the connection wires and/or bus bars in the same location using the capacitor
terminal screws.
• Replace safety shield, and close front panel door.
• Restart ATevo.
Copyright HindlePower Inc. 2021
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Last modified: 12 September 2023
Page 277 of 311