HindlePower Atevo Series Operating/Service Instructions Manual page 251

Microprocessor-controlled float battery charger three phase input 16-1000 adc output
Hide thumbs Also See for Atevo Series:
Table of Contents

Advertisement

HindlePower Inc
13.4.
13.4. Wiring ATevo Chargers for Forced
Wiring ATevo Chargers for Forced
Load Sharing
Load Sharing
All ATevos required to share load on the same dc bus must be connected to the same network.
The network will consist of a twisted pair cable with ground. The Serial Communication
Adapters (A13) on each ATevo must be parallel wired, point-to-point as follows:
Copyright HindlePower Inc. 2021
W W iring for F
iring for For orced L
ced Load Sharing
oad Sharing
Cable
Cable W W ir ire e A A T T evo
evo-A -A A A T T evo
(-)
RA(-)
1
(+)
RB(+)
GND GND
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
evo-B -B
RA(-)
RB(+)
GND
Last modified: 2 August 2023
Page 251 of 311

Advertisement

Table of Contents
loading

This manual is also suitable for:

Atevo o&si-3ph

Table of Contents