HindlePower Atevo Series Operating/Service Instructions Manual page 218
Microprocessor-controlled float battery charger three phase input 16-1000 adc output
Hide thumbs
Also See for Atevo Series:
- Operating/service instructions manual (164 pages) ,
- Operations (173 pages) ,
- Operating/service instructions manual (316 pages)
Table of Contents
Advertisement
HindlePower Inc
5. Connect wiring (#22-14 AWG) to appropriate terminals on the Auxiliary I/O Board
(A4-TB1).
6. Strip each wire 0.25in / 6.4mm, and tighten terminal screws.
7. Replace the safety shield.
8. Re-energize ATevo.
Notes
Notes
• Binary Inputs are configurable for 12Vdc, 24Vdc, 48Vdc, or 130Vdc.
• Terminal block (A4-TB1) is compression type, accepting #22-14 AWG wire.
• Correct polarization is required.
Copyright HindlePower Inc. 2021
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Last modified: 1 August 2023
Page 218 of 311
Advertisement
Table of Contents
