HindlePower Inc
• Both the TempCo shield and the original ground wire are connected to the EARTH quick-
connect terminal (A2-EARTH).
• The twisted-pair wires of the TempCo cable are connected to the 2-position terminal block
on the Power Board (A2-TB8).
15. Replace the safety shield and close the front panel door.
16. Restart the ATevo.
10.2.1 Configuring the TempCo Option
10.2.1 Configuring the TempCo Option
ATevo will need to be configured to enable the TempCo probe (A10) and to select the battery
type. Refer to
Section 4.11 Configuring Battery Settings
Copyright HindlePower Inc. 2021
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
for both.
Last modified: 13 September 2023
Page 196 of 311