HindlePower Atevo Series Operating/Service Instructions Manual page 40

HindlePower Inc
2.2. 2.2. Removing Protective Safety Shield Removing Protective Safety Shield
To prevent injuries, the ATevo safety shield must always be installed when
charger is in operation and/or energized.
2.2.1 Style-5070 Enclosure Instructions 2.2.1 Style-5070 Enclosure Instructions
• Standard Phillips head screwdriver is required.
• Open ATevo front panel door to access safety shields.
• Remove four (4) screws from corners of top shield and (4) screws from corners of bottom
shield.
• Grab shield while removing the last screw, and gently remove.
• Reverse procedure for reinstalling the safety shields.
2.2.2 Style-5030 Enclosure 2.2.2 Style-5030 Enclosure
*Standard Phillips head screwdriver is required. *Standard Phillips head screwdriver is required.
• Open ATevo front panel door to access safety shields.
• Remove six (6) screws from corners of top shield and (6) screws from corners of bottom
shield.
• Grab shield while removing the last screw, and gently remove.
• Reverse procedure for reinstalling the safety shields.
2.2.3 Style-163 & Style-198 Enclosures 2.2.3 Style-163 & Style-198 Enclosures
• Larger units not not supplied with safety shields.
Copyright HindlePower Inc. 2021
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Last modified: 13 September 2023
Page 40 of 311