HindlePower Atevo Series Operating/Service Instructions Manual page 235

HindlePower Inc
12.6. 12.6. Software Configuration for Analog Software Configuration for Analog
Inputs Inputs
The Auxiliary I/O Board analog inputs are used to monitor, alarm, and/or report on the status of
any external transducer or sensor. Each input can be scaled such that the value is reported in
primary units (°C, Vac, etc.).
The analog inputs can also generate alarms when their reported values are below, above, or
out-of-range of a configured valued. ATevo assigns each input a unique generic name that may
be replaced by the user.
*
Sof Softwar tware Configuration Naming e Configuration Naming: In the following subsections, Auxiliary I/O Board
analog inputs' default names are specified by board number (see Section
12.3.1), and analog input number on the associated board. For example: 'Aux 1
input AN2' specifies analog input #2 on Auxiliary I/O Board #1.
Copyright HindlePower Inc. 2021
ATevo O&SI - 3PH Input (16-1000 Adc) - 1.1_en
Last modified: 1 August 2023
Page 235 of 311